Skip to content
IJZIsaac Johan Ziebarth

Team project · UQ Space · 2026

Launch-site weather station

98,218 rows passed

A weather station UQ Space sets up at the launch site, so the pre-flight apogee prediction can use wind and pressure measured on site. I wrote its first design and rewrote most of its firmware. At the 2026 Australian Universities Rocket Competition it logged about 7 hours over 2 days, and all 98,218 checksummed rows on its card, bench tests included, passed.

My role
Lead avionics engineer. Wrote the first design and parts list, rewrote most of the firmware and sourced the parts. Wrote 30 of the repository's 39 commits. A teammate built the prototype
Team
UQ Space avionics team
When
Jun – Oct 2026
Tools
Arduino Mega, Heltec LoRa (915 MHz), BME280, C++, Fusion 360
Code
Private: UQ Space team repositories
Live figureweather-station-exploded.html

The full write-up

  1. The problem
  2. What I did
  3. Specifications
  4. Result
  5. What went wrong
  6. Credits

The problem

The team's pre-flight apogee prediction needs the wind and pressure at the launch site on the day.

What I did

  • An Arduino Mega reads a wind and rain kit and a BME280, and writes every sample to SD first.
  • A Heltec LoRa board relays about every second row on 915 MHz to a second board at the ground station.
  • My firmware rewrite appends to the log, keeps sampling and transmitting when the SD card or a sensor drops out, and puts a 16-bit cyclic redundancy check (CRC-16) and a sequence number on every row.
  • I built the station's 3D-printed enclosure, which housed it at the 2026 Australian Universities Rocket Competition.

Specifications

ControllerArduino Mega 2560
SensorsDFRobot SEN0186 wind and rain kit, BME280
RadioHeltec WiFi LoRa 32 V3, 915 MHz
LoggingmicroSD at 1 Hz; CRC-16 and sequence number on every row
PowerUSB power bank, 10 to 20 Ah
Enclosure3D printed; the Fusion design specifies ASA
Hover over or tap a part, or tab in and use the arrow keys, to take the station apart and name each part; the Arduino Mega, which runs the firmware I rewrote, is the board outlined in red. Drawn from the enclosure's Fusion design, with each board where the CAD puts it: the Arduino Mega and the SEN0186 adapter on the floor, the microSD breakout between them, the Heltec LoRa board raised on its headers with its antenna through the lid, and the BME280 on the right wall behind a vent.

Result

The station logged at 1 Hz, and its pressure and wind went into our last pre-launch prediction.

What went wrong

The prototype deleted its log on every boot, and a loose SD card or sensor wire stopped the radio as well. Fixing those two faults set the priorities for the rewrite.

Credits

A teammate built the prototype. The station is a UQ Space avionics team project.