Skip to content
IJZIsaac Johan Ziebarth

METR4810 · team of 4 · 2026

A steered cutter pod for a tunnel-boring robot

steered cutter pod

The machine bored through both end blocks at the final demonstration, but the pod would not steer deep in the bend, so the two passes did not meet; I traced it to an under-torqued steering servo.

My role
Steering and navigation lead in a team of 4; I designed the steered cutter pod
When
Jul – Oct 2026
Tools
Fusion 360, 3D printing
Files
Not published
Live figuremetr4810-pod-section.webp
A steered cutter pod for a tunnel-boring robot

The full write-up

  1. The problem
  2. What I did
  3. Result
  4. What went wrong
  5. Credits

The problem

A rig pushes an arm through three foam blocks, and the cutter on the end of the arm has to bore a tunnel that follows a curve, so the head must steer as it advances.

What I did

  • I replaced the team's first concept, 18 joints along the arm, with a single steered hinge just behind the cutter.
  • I designed the hinge, the servo gear drive and the cutter head in Fusion 360.
  • I derived the pod's steering schedule from the tunnel's geometry.
  • A week-11 redesign of the cutter head cut its mass from 16.0 g to 6.7 g.
Render of the cutter pod: the black servo and gear hood at the back, the white printed hinge and pod body, and the cutter head at the front
The pod as designed, rendered in Fusion 360.

Result

  • At the final demonstration the machine bored through both end blocks.
  • The pod would not steer deep in the bend, so the two passes did not meet.

What went wrong

  • Steering torque: my failure analysis traced it to the steering servo, which had too little torque for the side load from cutting.

Credits

METR4810 was a team project at UQ. The rig, the electronics and the base firmware are teammates' work; the page covers the cutter pod I designed.